connect two or more computers with cross cable

Network there may be a madman who have the heart to carry around a cable utp crossing type complete with carrying her laptop in a bag at all times. The author was never in such conditions. Usually this happens because people are crazy these networks have always wanted to do the work in different places with two PCs at once. :). Although at present there is a tool that is not bothered and can not be used to convolve the neck. : D. Ie USB WLAN. But there are conditions that do not allow to be able to use the usb wlan, such as economic conditions madman thin bags that network, although only spend a few sheets of paper money to buy it, but still this is the crux of the problem, and various other obstacles. : D

That's where this tutorial starts, before it can connect two PCs using a cable crossing there are some things that are needed include:
- Tang kerimping
- 2 pieces of RG 45
- 5e UTP cable with sufficient length, in accordance with your taste
- 2 PCs to be connected.
First disconnect the cable shield (shield wires are usually colored gray) a few centimeters (2 cm), by cutting the shield can use kerimping pliers, then straighten your straight-wires are colorful, and then sort based on coloring the cable at one end UTP cable. The sequence is as follows:

This is a sequence of straight wire, so to the other end of the cable wires staining sequence must be different from the sequence of the cable end of this straight, this is called a cross cable, cross cable end sequence is like this:

So at both ends of the cable has a different color sequence from each other.

The full sequence like this ...

Now from here you are ready to connect 2 PC.
In windows to connect two PCs as well as connect a PC with a network topology that is often encountered, usually it is a star network topology in which the pertengahannya commonly encountered using a hub or switch. This must be done to connect the two PCs in windows are as follows:
PC First
Enter the network connection in control panel:
Start menu | Run | control panel
After that go into the Network Connections
Then select Local Area Network Connection

Right-click the Local Area Network Connection, select Properties

In the dialog box Local Area Network Connection Properties, on the General tab select Internet Protocol (TCP / IP) then click Properties

Then enter the IP address 192.168.1.2 and netmask 255.255.255.0

After that click button OK, then Close
Well for the second step of the PC just the same as above but with different IP addresses Addressnya PC before, you can fill it with IP 192.168.1.x 192.168.1.1 or with others, it's up to you. With netmasknya records must be equal to the previous pc which is 255.255.255.0
Then the next step is to configure the network setup wizard for both the PC, so that both can be connected as a workgroup.
When finished, do a ping from one PC to the other PC ... If it looks like this then you have a PC connected to each other.
C: Documents and SettingsAl-k> ping 192.168.1.1
Pinging 192.168.1.1 with 32 bytes of data:
Reply from 192.168.1.1: bytes = 32 time <1ms TTL = 128
Reply from 192.168.1.1: bytes = 32 time <1ms TTL = 128
Reply from 192.168.1.1: bytes = 32 time <1ms TTL = 128
Reply from 192.168.1.1: bytes = 32 time <1ms TTL = 128
Ping statistics for 192.168.1.1:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms
Congratulations ...: D